立体网状填料是如何安装的

 立体网状填料是如何安装的

河南华信环保科技立体网状填料安装由于立体网状填料是整体式安装填料，具有安装方便、快捷的特点。需要入池检修时，也可方便的将填料拉出，并不破坏填料的结构。

　　安装立体网状填料的反应容器中，需要在下部设置格栅，格栅用以支承填料及填料上附着的生物膜的重量。由于立体网状填料单块截面积较大，格栅间隙可采用150~200mm，一般采用角钢+扁钢制作，或采用角钢框架+园钢。采用环氧树酯漆或沥青漆防腐。在制作格栅支架时，支架的强度应能满足立体网状填料所附着的全部生物膜的湿重，并应大于安装时工人踩踏时的重量。

　　立体网状填料单块的高度在订货时向厂家明确，厂家可根据用户需要生产所需高度的产品，便于整体安装。立体网状填料安装时，根据反应容器池型，顺序垂直码放，阜新立体网状填料块与块之间应互相挤紧，以防止填料在水流冲动下上浮。

Three dimensional mesh packing is how to install the

Henan Huaxin environmental protection technology of three-dimensional network of the filler is installed the three-dimensional mesh packing is integral mounting filler has the characteristics of convenient installation,. When the need to access the pool, it can also be convenient to pull out the filler, does not damage the structure of the filler.

The lower part of the reaction container is provided with a grid, and the grid is used to support the weight of the biological film attached on the filler and the filler. Due to the three-dimensional mesh packing single cross-sectional area larger grille clearance can use 150 200 mm. In general, the angle steel and flat steel production, or with angle steel frame and steel park. The use of epoxy resin paint or paint anti-corrosion paint. In making the grid frame, the strength of the support should be able to meet the wet weight of all the biological membrane attached to the solid mesh filler, and should be greater than the weight of the workers when the installation is installed.

The height of the solid mesh packing single block is clear to the manufacturers when ordering, and the manufacturer can produce the required products according to the needs of users, and is convenient for the whole installation. Three-dimensional reticular filler installation, according to the reaction container pool type, vertical stacking sequence, Fuxin stereoscopic and netted filler blocks and between the blocks should be mutually squeezed tight, to prevent packing under the impulsion of the water flow float.

河南华信环保科技您身边的水解专家！